Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 992

MANUAL TRANSMISSION OVERHAUL -
"A"
Gear
Synchronizer
ring
INSPECTION
INPUT SHAFT
(1) There must be no damage, abnormal wear or seizure
on the outer diameter of the needle bearing installation
section.
(2) Check the spline for damage and wear.
NEEDLE BEARING
(1) When the needle bearing is assembled with the input
shaft and gears and rotated, the needle bearing must
rotate smoothly without play or abnormal noise.
(2) The holder must not be deformed.
SYNCHRONIZER RING
(1) The clutch gear teeth must not be damaged or broken.
(2) The inner diameter of the cone must not be damaged
or worn, and the screw threads must not be crushed.
(3) Press the synchronizer ring against the gears, and check
the clearance "A". Replace if "A" is less than the limit
value.
Limit value: 0.5 mm
OUTER SYNCHRONIZER RING, INNER
SYNCHRONIZER RING AND SYNCHRONIZER CONE
(1) The gear teeth and cone surface must not be damaged
or broken.
Input Shaft
22B-27