Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 997

22B-32
MANUAL TRANSMISSION OVERHAUL -
Synchronizer
spring
1st
speed
side
Installation
direction
Synchronizer hub
MD998364
1st
Identification
speed
groove
side
Installation
direction
Synchronizer sleeve protrusion section
Synchronizer hub deep groove section
"DA SYNCHRONIZER SPRING INSTALLATION
Install the synchronizer spring at the position shown in the
illustration.
"EA 1ST-2ND SPEED SYNCHRONIZER HUB
2nd
Using the special tool, install the 1st-2nd speed synchronizer
speed
side
hub onto the output shaft in the direction shown in the
illustration.
Caution
MD998812
(1) Press in so that the synchronizer ring does not bite
(2) After assembling, confirm that the 1st speed gear
MD998814
MD998824
"FA SYNCHRONIZER SLEEVE INSTALLATION
2nd
speed
(1) Install the synchronizer sleeve onto the output shaft at
side
(2) Align the synchronizer hub deep grooves with the sleeve
Output Shaft
in.
rotates smoothly.
the direction shown in the illustration.
protrusions and install onto the output shaft.