Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 597

52B-66
Instrument panel wiring
harness
(2-pin, red)
Front passen-
ger's air bag
module 2-pin
connector (red)
Deployment harnesses
SRS air bag
adapter harness
MB686560
SRS air bag
adapter harness
MB686560
Front passenger's
air bag module 2-pin
connector (red)
Deployment
harnesses
Deployment
harnesses
Air Bag Module and Seat Belt Pre-tensioner
SRS -
Disposal Procedures
connector
Shorted
6 m or longer
Insulation
tape
Cover
Front passenger's air bag module
(1) Remove the glove box.
(Refer to GROUP 52A – Instrument Panel.)
(2) Disconnect the front passenger's air bag module 2-pin
connector (red) and instrument panel wiring harness
connector (2-pin, red).
NOTE
Once disconnected from the instrument panel wiring
harness, both electrodes of the front passenger's air
bag module short automatically. This prevents the
front passenger air bag from accidental deployment
caused by static, etc.
(3) Connect deployment harnesses longer than 6 m to
each SRS air bag adapter harness and insulate the
connections with plastic tape.
Also, connect the deployment harnesses in the other
ends to short,
passenger's air bag from accidental deployment
caused by static etc.
(4) Connect the SRS air bag adapter harness to the
front passenger's air bag module 2-pin connector
(red) and route the deployment harnesses out of the
vehicle.
(5) Close all the doors with the windows fully closed and
put a cover over the vehicle to minimize report.
Caution
The cover is required as the glass, if already
damaged, may break.
thereby preventing the front