Mitsubishi Electric Lancer Evolution-VII Workshop Manual page 450

(V)
(H)
High intensity zone
Vertical
direction
Vertical
direction
CHASSIS ELECTRICAL - CHASSIS ELECTRICAL -
2. Check if the high beam shining onto the screen is at the
Lamp centre
3. Alternately turn the adjusting screw to adjust the headlamp
Horizontal
direction
Horizontal
direction
<USING A BEAM SETTING EQUIPMENT>
1. The headlamps should be aimed with the proper beam
2. Alternately turn the adjusting screw to adjust the headlamp
Headlamp Assembly Headlamp Assembly
standard value.
Standard value:
(Vertical and horizontal direction)
The center of high intensity zone is on the
point of intersection of line (H) and line (V).
Limit:
(Vertical direction) - 0.5_ of the point of
intersection of line (H)
(Horizontal direction) ± 0.5_
of line (V)
high beam aiming.
Caution
Be sure to adjust the aiming adjustment screw in
the tightening direction.
setting equipment, and in accordance with the equipment
manufacture's instructions.
NOTE
If there are any regulations pertinent to the aiming of
headlamps in the area where the vehicle is to be used,
adjust so as to meet those requirements.
aiming. (Refer to P.54A-24.)
54A-27
of the center