Removing The Agitation-Manifold Valve - Toro Multi Pro 5800-D Installation Instructions Manual

Note: Squeeze the 2 legs of the retainer together while
pushing it down.
Note: Retain the actuator and retainer for installation
in Installing the Valve Actuator (page
Figure 133
Section-Valve Actuator Shown (the agitation-valve actuator
1. Valve actuator (section
valve shown)
2. Retainer
4. Remove the actuator from the manifold valve.

Removing the Agitation-Manifold Valve

1. Remove the clamps and gaskets that secure the
manifold for the agitation valve to the agitation bypass
valve, pressure-filter head, reducer coupling, and
adapter fitting (agitation throttle valve) as shown in
Figure 134.
Note: Retain the clamps, gaskets, quick connect, and
quick-connect pin for installation in
Agitation-Manifold Valve (page
62).
is similar)
3. Stem port
Installing the
61).
1. Flange (pressure-filter
head)
2. Manifold (agitation valve)
3. Flange (agitation bypass
valve)
4. Flange clamp
2. Remove the agitation-valve manifold from the machine
(Figure 135).
57
Figure 134
Agitation Valve
5. Gasket
6. Flange (adapter
fitting—agitation throttle
valve)
7. Flange (reducer coupling)