Toro Multi Pro 5800-D Installation Instructions Manual page 28

Installing the Section Bypass Hose
Machines without the Optional Eductor Kit
Important: If you are installing the conversion valve
kit on a machine with an optional eductor kit, skip this
procedure and complete
and Hoses for the Optional Eductor Kit (page
1. Rotate the upper T-fitting approximately 80°
counterclockwise (Figure
Figure 58
1. Upper T-fitting
2. Assemble the 90° barbed fitting of the agitation bypass
hose—25 x 254 mm (1 x 10 inches) to the upper
T-fitting (Figure 59) with the retainer that you removed
in step 2 of Removing the Agitation Bypass and Sprayer
Supply Hoses (page
12 Installing the Shutoff Valve
29).
58).
17).
1. Upper T-fitting
2. Flange (agitation bypass
valve)
3. Retainer
4. 90° barbed fitting
3. Secure the barbed flange fitting of the agitation bypass
hose and the gasket—25 x 35 mm (1 x 1-3/8 inches) to
the flange of the agitation bypass valve
a flange clamp—40 to 64 mm (1-9/16 to 2-1/2 inches).
28
Figure 59
5. Barbed flange fitting
6. Gasket—25 x 35 mm (1 x
1-3/8 inches)
7. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches)
8. Agitation bypass hose—25
x 254 mm (1 x 10 inches)
(Figure 59) with