Toro Multi Pro 5800-D Installation Instructions Manual page 13

Figure 24
1. Right—up (solenoid and
main-harness connector)
2. Left—up (solenoid and
main-harness connector)
3. Front of the machine
5. At the back of the machine—inboard of the sprayer
pump, disconnect the 2-socket connector of the rear
wire harness from the 2-pin connector of the relay for
the pump (Figure 25).
Figure 25
1. 2-pin connector (pump
relay)
2. 2-socket connector (rear
wire harness)
6. Remove the push-in fastener that secures the rear wire
harness (Figure 26) to the holes in the rear cross tube
(rearward of the hydraulic-traction motors).
4. Enable (solenoid and
main-harness connector)
5. Right—down (solenoid
and main-harness
connector)
6. Left—down (solenoid and
main-harness connector)
3. Front of the machine
1. Sprayer pump
2. Rear cross tube
7. Remove the pressure-sense tube for the dash gauge
from the rear wire harness from the machine
27).
1. Pressure-sense tube
(dash gauge)
8. Remove the rear wire harness from the machine.
Note: You no longer need the rear wire harness that
you removed from the machine.
13
Figure 26
3. Rear wire harness
4. Push-in fastener
Figure 27
2. Rear wire harness
(Figure