Installing The Drain Valve - Toro Multi Pro 5800-D Installation Instructions Manual

Installing the Bypass Hose
1. Assemble the 90° barbed fitting of the bypass hose—2.5
x 64 cm (1 x 25 inches) onto the quick-connect fitting
at the bypass-shutoff valve
Figure 77
Figure 78
1. Quick-connect fitting
(bypass-shutoff valve)
2. 90° barbed fitting (bypass
hose)
2. Secure the 90° barbed fitting to the quick-connect
fitting with the retainer that comes with the bypass and
drain-hose assembly
3. Secure the bottom of the bypass hose to the rear saddle
plate of the machine
clamp, flange-head bolt (5/16 x 3/4 inch), and washer
(5/16 inch).
(Figure 77 and Figure
3. Retainer
(Figure 78).
(Figure 79) with the support
78).
1. Washer (5/16 inch)
2. Flange-head bolt (5/16 x
3/4 inch)

Installing the Drain Valve

1. Assemble the cable of the lynch pin, flange-head bolt
(5/16 x 1 inch), and flange locknut (5/16 inch) that you
removed in step
the hole 8 mm (5/16 inch) in the rear, outboard corner
of the sprayer-pump bracket
36
Figure 79
3. Rear saddle plate
(machine)
4. Support clamp
4 of Preparing the Machine (page 5)
(Figure 80 and
Figure 80
to
Figure 81).