Product Overview - Toro Multi Pro 5800-D Installation Instructions Manual

20
Completing the Installation
of the Arag to KZ Valve
Conversion Kit
No Parts Required
Procedure
1. Move the prop rod for the seats into the slots and tilt
the seats down.
2. Connect the positive (red) cable to the positive (+)
battery post and the negative (black) cable to the
negative (–) battery post using the bolts and nuts; refer
to Figure 4 in Disconnecting the Battery (page
3. Slide the insulator boot over both battery posts ; refer
to Figure 4 in Disconnecting the Battery (page
4. Install the battery cover and secure it with the strap;
refer to Figure 3 in Disconnecting the Battery (page

Product Overview

Controls
Agitation Switch
The agitation switch is located on the center console to
the right of the seat; refer to the Operator's Manual for your
machine. Toggle this switch forward to turn on the agitation
in the tank or rearward to stop the agitation. When the switch
is turned on, a light on the switch illuminates. To operate the
agitation function, run the sprayer-system pump and run the
engine above low idle. The agitation valve is located behind
the tank (Figure
6).
6).
6).
1. Actuator (agitation valve)
Agitation Bypass Valve
The agitation bypass valve redirects the flow of fluid to
the sprayer-system pump when you turn off the agitation
function (Figure
above the agitation valve. You can adjust the bypass valve to
ensure that the pressure remains constant when cycling the
agitation on and off; refer to
Valve (page 55).
Agitation Throttle Valve
The agitation throttle valve is a manually operated ball valve
that controls flow to the agitation nozzles in the main tank.
This valve allows the user to control the sprayer-system
pressure at the agitation nozzles of the main tank when larger
application rates are required. The agitation throttle valve is
located above the pump
53
126).
Figure 126
2. Agitation-bypass-valve
handle
126). The agitation bypass valve is located
Calibrating the Agitation Bypass
(Figure 127).