Toro Multi Pro 5800-D Installation Instructions Manual page 40

2. Remove the straight barbed fitting (3/4 inch) and
retainer from the shut off valve
Note: If you are installing the valve conversion kit
onto a machine with an optional electric hose-reel
kit, retain the straight barbed fitting (3/4 inch)
and retainer for installation in
Hose—Machines with the Optional Electric Hose-Reel
Kit (page 42). If you are you installing the valve
conversion kit onto a machine with an optional spray
gun kit, you no longer need the straight barbed fitting
(3/4 inch) and retainer.
3. Assemble the flange shutoff valve into the nylon
bracket as shown in
4. Secure the nylon bracket to the flange shutoff valve
with the screw (6-32 x 5/8 inch) as shown in
87).
5. Assemble the T-fitting that you removed in step
of Disconnecting Pressure-Sense Tube and Supply
Hose—Optional Spray-Gun Kit or Electric Hose-Reel
Kit (page 9) into the 90° elbow with a pressure port
(Figure 88).
Figure 88
1. T-fitting
2. 90° elbow (with pressure
port)
3. Gasket—25 x 35 mm (1 x
1-3/8 inches)
6. Assemble the 90° elbow to the flange shutoff valve
(Figure 88) with a gasket—25 x 35 mm (1 x 1-3/8
inches)) and flange clamp—40 to 64 mm (1-9/16 to
2-1/2 inches).
(Figure 87).
Installing the Supply
(Figure 87).
(Figure
4. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches)
5. Flange shutoff valve
Installing the Shutoff Valve
1. Remove the flange clamp, 90° elbow assembly, and
gasket at the flange of the right-boom-section valve
(Figure 89).
Note: Retain the flange clamp and gasket for
installation in step 2. You no longer need the 90°
elbow assembly.
4
1. Gasket
2. Flange clamp
2. Assemble the 90° elbow and flange shutoff valve to the
flange of the right-boom-section valve with the flange
clamp and gasket that you removed in step 1.
1. Gasket
2. Flange clamp
40
Figure 89
3. Flange (boom-section
valve)
4. 90° elbow assembly
Figure 90
3. 90° elbow and flange
shutoff valve
4. Flange
(right-boom-section valve)