Toro Multi Pro 5800-D Installation Instructions Manual page 44

16
Assembling the Rear Wiring
Harness to the Machine
Parts needed for this procedure:
1 Rear wire harness
3 Cable tie
Routing Wire Harness Along the Frame
Tube
1. Locate the 168 cm (66 inches) branch of the new
electrical harness (Figure
Figure 101
1. 64 cm (25 inches)—lift
cylinder solenoids
2. 76 cm (30 inches)
wire-harness
branch—left, center,
and right spray valves,
agitation valve, and flow
meter
3. 74 cm (29 inches)
wire-harness
branch—spray-pump
solenoid
101).
4. wire-harness
branch—rinse pump,
hose-reel power, and
hose reel
5. 30 cm (12 inches)
wire-harness
branch—speed sensor
6. 168 cm (66 inches)
wire-harness
branch—front harness
interface connectors
2. Route the 168 cm (66 inches) of the new electrical
harness between the valve mount and right support for
the manifold mount
1. Manifold mount
3. 168 cm (66 inches) wire-harness branch of the electrical
harness forward along the right frame tube
103).
44
(Figure 102).
Figure 102
2. 168 cm (66 inches)
wire-harness
branch—front harness
interface connectors
(Figure