Toro Multi Pro 5800-D Installation Instructions Manual page 17

Removing the Agitation Bypass and
Sprayer Supply Hoses
1. Remove the retainer that secures the straight barbed
fitting for the agitation bypass hose to the agitation
bypass valve (Figure
Figure 36
1. 90° barbed fitting (agitation
Bypass Hose)
2. T-fitting (upper)
3. Retainers
2. Remove the retainer that secures the 90° barbed fitting
for the agitation bypass hose to the upper T-fitting
(Figure 36).
3. Remove the agitation bypass hose from the machine
(Figure 36).
4. Fully loosen the fly nut for the sprayer supply hose
from the threaded fitting of the master control valve
(Figure 37).
36).
4. Straight barbed fitting
(agitation Bypass Hose)
5. Agitation bypass valve
1. Straight barbed fitting
(sprayer supply hose)
2. Fly nut (sprayer supply
hose)
3. Straight barbed fitting—fly
nut (agitation supply hose)
5. Remove the retainer that secures the straight barbed
fitting of the sprayer supply hose and the T-fitting at
the sprayer pump
6. Remove the sprayer supply hose from the machine
(Figure 37).
Note: Retain the retainers that you removed in steps
1, 2, and 5 for installation
Hose (page 28)
Hose (page 28). You no longer need the agitation
bypass and sprayer supply hoses.
17
Figure 37
4. Threaded fitting (master
control valve)
5. Retainer
6. T-fitting (sprayer pump)
(Figure 37).
Installing the Section Bypass
and 11 Installing the Manifold Supply