Toro Multi Pro 5800-D Installation Instructions Manual page 50

Figure 118
1. 4-socket connector (rear
wire harness—labeled
H R )
OSE EEL
2. Connect the 4 pin connector of the jumper harness
into the 4-socket connector of the rear wire harness
labeled H R
OSE EEL
Figure 119
1. 6-pin connector—labeled
R S
ATE WITCH
I (
NTERCONNECT OPTIONAL
).
SPRAY GUN
2. 6-socket connector
(jumper harness)
3. At the back of the control box for the spray gun
or electric hose reel, locate the 6-pin connector
(Figure 119) labeled R
(
OPTIONAL SPRAY GUN
4. Connect the 6-pin connector (rate switch interconnect)
into the 6-socket connector of the jumper harness
(Figure 119).
Note: The 2-pin connector of the rear wire harness labeled
H R P is not used.
OSE EEL OWER
2. Cap
(Figure 119).
3. 4-socket connector (rear
wire harness—labeled
H R )
OSE EEL
4. 4 pin connector (jumper
harness)
S I
ATE WITCH NTERCONNECT
).
Connecting the Wire Harness to the
Optional Foam-Marker Kit
1. At the end of the 236 cm (93 inch) branch of the
wire harness, align the 4-socket connector of the wire
harness for the finishing kit with the 4-pin connector
of the wire harness from the compressor
1. Compressor
2. 4-pin connector (wire
harness for the
compressor)
2. Insert the 4-pin connector into the 4-socket connector
(Figure 120).
Note: Press the connectors together until the latch
snaps securely.
Connecting the Wire Harness to the
Optional Tank-Rinse Kit
1. Connect the 6-pin connector of the rinse-pump harness
from the 6-socket connector of the rear wire harness
labeled R P
INSE
50
(Figure
Figure 120
3. 4-socket connector (wire
harness for the finishing
kit)
(Figure 121).
UMP
120).