Toro Multi Pro 5800-D Installation Instructions Manual page 51

Figure 121
1. Rinse pump
2. 6-socket connector (rear
wire harness—labeled
R P )
INSE UMP
2. Align the rinse-pump cover over saddle plate for the
rinse pump (Figure
Figure 122
3. Press together the sides of the rinse-pump cover and
align the tabs of the cover with the saddle plate
122).
4. Insert the tabs into the slots and release the sides of the
cover (Figure 122).
Connecting the Wire Harness to the
Optional Pro Control Kit
Connect the 3-socket connector of the 76 cm (30 inches)
wire-harness branch for the flow meter (not labeled) into the
3-pin connector of the harness of the flow meter
3. 6-pin connector
(rinse-pump harness)
122).
(Figure
1. 3-socket connector (rear
wire harness—76 cm (30
inches) branch)
19
Connecting the
Pressure-Sense Tube for
the Dash Gauge
No Parts Required
Connecting the Pressure-Sense Tube
for the Dash Gauge—Machines Without
an Optional Hose-Reel Kit
1. Align the end of the pressure-sense tube (plastic) for
the pressure gauge in the dash with the locking collar
for the tube coupler
(Figure
123).
51
Figure 123
2. 3-pin connector
(flow-meter harness)
(Figure 124).