Toro Multi Pro 5800-D Installation Instructions Manual page 30

12
Installing the Shutoff Valve
and Hoses for the Optional
Eductor Kit
Parts needed for this procedure:
1 Eductor shutoff valve
1 Shutoff-valve bracket
1 Flange locknuts (1/4 inch)
1 Gasket—25 x 35 mm (1 x 1-3/8 inches)
1 Flange clamp—40 to 64 mm (1-9/16 to 2-1/2 inches)
Agitation bypass hose—25 x 337 mm (1 x 13-1/4
1
inches)
1 Gasket—25 x 35 mm (1 x 1-3/8 inches)
1 Flange clamp—40 to 64 mm (1-9/16 to 2-1/2 inches)
Pressure-relief hose—2.5 x 29.8 cm (1 x 11-3/4
1
inches)
Sprayer supply hose—2.5 x 48.6 cm (1 x 19-1/8
1
inches)
Eductor supply hose—2.5 x 156.5 cm (1 x 61-5/8
1
inches)
Installing the Agitation Shutoff Valve
1. Align the studs of the eductor shutoff valve with the
holes in the shutoff-valve bracket
Figure 61
1. Flange locknuts (1/4 inch)
2. Shutoff-valve bracket
(Figure 61).
3. Stud (eductor shutoff
valve)
2. Assemble the valve to the bracket
2 flange locknuts (1/4 inch) and torque the locknuts to
52 to 67 N∙m (46 to 60 in-lb).
3. At the front, left side of the valve mount, remove the
2 flange locknuts (5/16 inch) that secure the pressure
filter to the manifold bracket
Note: Do not remove the 2 bolts (5/16 x 3-3/4
inches) that secure the pressure filter,
1. Bolt (5/16 x 3-3/4 inches)
2. Manifold bracket
4. Align the flange of the eductor shutoff valve and
gasket—25 x 35 mm (1 x 1-3/8 inches) to the flange of
the filter head (Figure
1. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches)
2. Flange (filter head)
5. At the front side of the manifold bracket, align the
holes in the shutoff-valve bracket
2 bolts (5/16 x 3-3/4 inches).
30
(Figure 61) with the
(Figure 62).
Figure 62
3. Front of the machine
4. Flange locknuts (5/16
inch)
63).
Figure 63
3. Flange (eductor shutoff
valve)
4. Gasket—25 x 35 mm (1 x
1-3/8 inches)
(Figure 64) with the