Installation; Loose Parts - Toro Multi Pro 5800-D Installation Instructions Manual

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
Description
No parts required
No parts required
No parts required
Rear wire harness
No parts required
No parts required
No parts required
Sprayer-valve assembly
Cover—52 mm (2-1/16 inches)
Gasket—25 x 35 mm (1 x 1-3/8 inches)
Flange clamp—40 to 64 mm (1-9/16 to
2-1/2 inches)
Valve mount
Flange-head bolts (5/16 x 1 inch)
Flange locknuts (5/16 inch)
No parts required
Screw (6-32 x 5/8 inch)
Handle
Agitation throttle valve
Bracket (nylon)
Agitation-valve bracket
Bolt (6 x 12 mm)
Agitation supply hose
Agitation-nozzle assembly
Agitation bypass hose—25 x 254 mm
(1 x 10 inches)
Gasket—25 x 35 mm (1 x 1-3/8 inches)
Flange clamp—40 to 64 mm (1-9/16 to
2-1/2 inches)
Manifold supply hose (1 x 25 inches)
Gasket—25 x 35 mm (1 x 1-3/8 inches)
Flange clamp—40 to 64 mm (1-9/16 to
2-1/2 inches)
Qty.
–
Prepare to install the kit.
Disconnect the rear wire harness from
–
the optional attachment.
Disconnecting the pressure-sense tube
–
for the dash gauge.
Remove the rear wire harness for the
1
machine.
Remove the bypass, drain, and agitation
–
components.
–
Disassembling the supply hose.
Remove the valve support and
–
boom-section valves.
1
1
1
1 Assemble the valves to the valve mount.
1
5
5
–
Install the valve mount to the machine.
1
1
1
1
1
1
Install the agitation shutoff valve,
1
nozzles, and hoses.
1
1
1
1
1
1
Install the manifold supply hose.
1
3
Use