Lenovo RackSwitch G8264 Command Reference Manual page 763

© Copyright Lenovo 2017
Thread LOG_NOTICE Message (continued)
SSH scp<username>(<user type>) {logout|ejected|idle timeout|
connection closed} from {Console|Telnet/SSH}
SSH scp<username>(<user type>) login {on Console|from host
<IP address>}
SSH Wrong config file type
SYSTEM <SPF name> TX Fault ‐ <SFP type> is DISABLED
SYSTEM <SPF name> UnApproved ‐ <SFP type> is DISABLED
SYSTEM <SFP type> inserted at port <port> is UNAPPROVED ! Device is
DISABLED.
SYSTEM Address for interface <interface> ignored because of mismatch.
SYSTEM BOOTP Offer (continue): Domain name: <domain>
SYSTEM BOOTP Offer (continue): Host name: <host>
SYSTEM BOOTP Offer (continue): Primary DNS: <IP address>, Secondary
DNS: <IP address>
SYSTEM Change fibre GIG port <port> mode to full duplex
SYSTEM Change fibre GIG port <port> speed to 1000
SYSTEM Changed ARP entry for IP <IP address> to: MAC <MAC address>,
Port <port>, VLAN <VLAN>
SYSTEM Could not add L2 multicast entry! L2 table is full.
SYSTEM ECMP route gateway <IP address> [via if <interface>] is {down|up}
SYSTEM Enable auto negotiation for copper GIG port: <port>
SYSTEM Fan Fault {Detected|Cleared}. Fan <fan number> RPM <RPM
value>
SYSTEM Fan Failure Warning Cleared
SYSTEM I2C device <ID> <description> set to access state <state> [from CLI]
SYSTEM L2 table is full!
SYSTEM Mask for interface <interface> ignored because of mismatch.
SYSTEM **** MAX TEMPERATURE (<temperature>) ABOVE FAIL THRESH
****
SYSTEM **** MAX TEMPERATURE (<temperature>) ABOVE WARN
THRESH ****
SYSTEM **** PLATFORM THERMAL SHUTDOWN ****
SYSTEM Port <port> disabled
SYSTEM Port <port> disabled by BPDU Guard
Appendix A: Enterprise NOS System Log Messages
763