Iscli Command Modes - Lenovo RackSwitch G8264 Command Reference Manual

ISCLI Command Modes

Table 2. ISCLI Command Modes
Command Mode/Prompt
User EXEC
RS G8264>
Privileged EXEC
RS G8264#
Global Configuration
RS G8264(config)#
Interface IP
RS G8264(config­ip­if)#
22
G8264 Command Reference for ENOS 8.4
The ISCLI has three major command modes listed in order of increasing privileges,
as follows:
 User EXEC mode
This is the initial mode of access. By default, password checking is disabled for
this mode, on console.
 Privileged EXEC mode
This mode is accessed from User EXEC mode. This mode can be accessed using
the following command: enable
Global Configuration mode

This mode allows you to make changes to the running configuration. If you save
the configuration, the settings survive a reload of the G8264. Several sub‐modes
can be accessed from the Global Configuration mode. For more details, see
Table 2. This mode can be accessed using the following command: configure
terminal
Each mode provides a specific set of commands. The command set of a
higher‐privilege mode is a superset of a lower‐privilege mode—all lower‐privilege
mode commands are accessible when using a higher‐privilege mode.
The following table lists the ISCLI command modes.
Command used to enter or exit
Default mode, entered automatically on console
Exit: exit or logout
Enter Privileged EXEC mode, from User EXEC mode:
enable
Exit to User EXEC mode: disable
Quit ISCLI: exit or logout
Enter Global Configuration mode, from Privileged EXEC mode:
configure terminal
Exit to Privileged EXEC: end or exit
Enter Interface IP Configuration mode, from Global
Configuration mode:
interface ip <1‐128>
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end