Lenovo RackSwitch G8264 Command Reference Manual page 539

© Copyright Lenovo 2017
Table 283.
OSPF Interface Configuration Options (continued)
Command Syntax and Usage
[no] ip ospf passive­interface
Sets the interface as passive. On a passive interface, you can disable OSPF
protocol exchanges, but the router advertises the interface in its LSAs so that IP
connectivity to the attached network segment will be established.
Command mode: Interface IP
[no] ip ospf point­to­point
Sets the interface as point‐to‐point.
Command mode: Interface IP
ip ospf priority <0‐255>
Configures the priority value for the G8264's OSPF interfaces.
A priority value of 255 is the highest and 1 is the lowest. A priority value of 0
specifies that the interface cannot be used as Designated Router (DR) or
Backup Designated Router (BDR).
Command mode: Interface IP
ip ospf retransmit­interval <1‐3600>
Configures the retransmit interval in seconds.
Command mode: Interface IP
ip ospf transit­delay <1‐3600>
Configures the transit delay in seconds.
Command mode: Interface IP
no ip ospf
Deletes the OSPF interface.
Command mode: Interface IP
show interface ip <1‐128> ospf
Displays the current settings for OSPF interface.
Command mode: All
Chapter 4: Configuration Commands
539