Ospfv3 Interface Configuration - Lenovo RackSwitch G8264 Command Reference Manual

OSPFv3 Interface Configuration

© Copyright Lenovo 2017
The following table describes the OSPFv3 Interface commands.
Table 292.
OSPFv3 Interface Configuration Options
Command Syntax and Usage
interface ip <1‐128>
Enter Interface IP mode, from Global Configuration mode.
Command mode: Global configuration
ipv6 ospf area <0‐2>
Configures the OSPFv3 area index.
Command mode: Interface IP
ipv6 ospf area <0‐2> instance <0‐255>
Configures the instance ID for the interface.
Command mode: Interface IP
ipv6 ospf cost <1‐65535>
Configures the metric value for sending a packet on the interface.
Command mode: Interface IP
no ipv6 ospf cost
Removes the metric value for sending a packet on the interface.
Command mode: Interface IP
ipv6 ospf dead­interval <1‐65535>
Configures the time period, in seconds, for which the router waits for hello
packet from the neighbor before declaring this neighbor down.
Command mode: Interface IP
no ipv6 ospf dead­interval
Resets the dead interval for hello packets to its default value.
Command mode: Interface IP
[no] ipv6 ospf enable
Enables or disables OSPFv3 on the interface.
Command mode: Interface IP
ipv6 ospf hello­interval <1‐65535>
Configures the indicated interval, in seconds, between the hello packets, that
the router sends on the interface.
Command mode: Interface IP
no ipv6 ospf hello­interval
Resets the hello interval for hello packets to its default value.
Command mode: Interface IP
Chapter 4: Configuration Commands
551