LLDP Configuration
478
G8264 Command Reference for ENOS 8.4
Use the following commands to configure Link Layer Detection Protocol (LLDP).
Table 237.
LLDP Configuration Options
Command Syntax and Usage
[no] lldp enable
Globally enables or disables LLDP.
The default setting is enabled.
Command mode: Global configuration
lldp holdtimemultiplier <2‐10>
Configures the message hold time multiplier. The hold time is configured as a
multiple of the message transmission interval.
The default value is 4.
Command mode: Global configuration
no lldp holdtimemultiplier
Resets the message hold time multiplier to its default value of 4.
Command mode: Global configuration
lldp refreshinterval <5‐32768>
Configures the message transmission interval, in seconds.
The default value is 30 seconds.
Command mode: Global configuration
no lldp refreshinterval
Resets the message transmission interval to its default value of 30 seconds.
Command mode: Global configuration
lldp reinitdelay <1‐10>
Configures the re‐initialization delay interval, in seconds. The re‐initialization
delay allows the port LLDP information to stabilize before transmitting LLDP
messages.
The default value is 2 seconds.
Command mode: Global configuration
no lldp reinitdelay
Resets the re‐initialization delay interval to its default value of 2 seconds.
Command mode: Global configuration
lldp transmissiondelay <1‐8192>
Configures the transmission delay interval, in seconds. The transmit delay
timer represents the minimum time permitted between successive LLDP
transmissions on a port.
The default value is 2 seconds.
Command mode: Global configuration