OSPF Interface Configuration
538
G8264 Command Reference for ENOS 8.4
The following table describes the OSPF Interface commands.
Table 283.
OSPF Interface Configuration Options
Command Syntax and Usage
ip ospf area <0‐19>
Configures the OSPF area index.
Command mode: Interface IP
ip ospf cost <1‐65535>
Configures cost set for the selected path—preferred or backup. Usually the
cost is inversely proportional to the bandwidth of the interface. Low cost
indicates high bandwidth.
Command mode: Interface IP
ip ospf deadinterval <1‐65535>
ip ospf deadinterval <1000‐65535 ms>
Configures the health parameters of a hello packet, in seconds or
milliseconds, before declaring a silent router to be down.
Command mode: Interface IP
[no] ip ospf enable
Enables or disables the OSPF interface.
Command mode: Interface IP
ip ospf hellointerval <1‐65535>
ip ospf hellointerval <50‐65535 ms>
Configures the interval, in seconds or milliseconds, between the hello
packets for the interfaces.
Command mode: Interface IP
ip ospf key <key string>
Sets the authentication key to clear the password.
Command mode: Interface IP
no ip ospf key
Removes the authentification key to clear the password.
Command mode: Interface IP
ip ospf messagedigestkey <1‐255>
Assigns an MD5 key to the interface.
Command mode: Interface IP
no ip ospf messagedigestkey
Removes the MD5 key form the interface.
Command mode: Interface IP