Komatsu PC200-8M0 Shop Manual page 430

SEN06128-00
a If you do not touch any of the function
switches and working mode selector
switch for 5 seconds, the selection is
determined and the screen changes to the
standard screen.
3. When the ordinary screen is displayed again,
large working mode monitor (a) is displayed for
2 seconds, and then the setting of the working
mode is changed to the selected mode.
a When large monitor (a) is displayed, the
display of working mode monitor (b) is
changed, too.
<Precautions for selecting breaker mode [B]>
q If breaker mode [B] is selected, both of the
control of the hydraulic pump and the set-
ting of the hydraulic circuit are changed.
If an attachment other than the breaker is
q
used, the machine may move unexpect-
edly or may not operate normally or the
hydraulic components may be damaged.
q After the breaker mode is selected, the
screen to confirm the selection of the
breaker mode is displayed (The buzzer
sounds intermittently while this screen is
displayed).
q If the setting is confirmed on this screen,
the screen changes to the standard
screen.
10
30-102
102 Testing and adjusting, Part 2
Special functions of machine monitor
If "No" is selected: Screen returns to work-
ing mode selecting screen
If [Yes] is selected: Working mode is set to
breaker mode [B]
Selection of travel speed
While the standard screen is displayed, if the travel
speed selector switch is pressed, large travel
speed monitor (a) is displayed for two seconds and
the setting of the travel speed is changed.
a Travel speed setting sequentially changes
between [Lo] o [Mi] o [Hi] o [Lo] in this order
every time the switch is pressed.
a When large monitor (a) is displayed, the dis-
play of travel speed monitor (b) is changed,
too.
Operation to stop alarm buzzer
While the alarm buzzer is sounding, if the alarm
buzzer cancel switch is pressed, the alarm buzzer
stops.
a Even if the alarm buzzer cancel switch is
pressed, the screen display does not change.
PC200, 200LC, 220, 220LC-8M0