Komatsu PC200-8M0 Shop Manual page 26

SEN06112-00
Revised edition mark
q
When a manual is revised, the ones and tens digits of the form number of each brochure is increased by
1. (Example: 00, 01, 02 ...)
q Revisions
Revised brochures are shown in the shop manual composition table.
Symbol
Important safety and quality portions are marked with the following symbols so that the shop manual is used
practically.
Symbol
k
a
4
3
Tightening
2
5
Oil, coolant
6
Unit
q In this shop manual, the units are indicated with International System of units (SI).
q For reference, Gravitational System of units which is used to be used is indicated in parentheses of { }.
10
00-200
Item
The special safety precautions required for performing work are
Safety
described.
The special technical precautions or other precautions for preserving
Caution
standards required when performing work are described.
The weight of part or component and the cautions required when
Weight selecting hoisting wire or when working posture is important are
described.
The tightening torques that require special attention during assembly
torque work are described.
The places to be coated with adhesives, etc. during assembling are
Coat
indicated.
The places to which oil is supplied and the quantity of the oil are indi-
cated.
The places from which oil is drained and quantity of the oil are indi-
Drain
cated.
200 Foreword and general information
How to read the shop manual
Remarks
PC200, 200LC, 220, 220LC-8M0