SEN06112-00
Type 2
Disconnection
1.
While holding the fitting, push body (7) in
straight until sliding prevention ring (6) hits
contact surface (a) at the hexagonal part on
the male side. (Fig. 6)
2.
While keeping the condition of Step 1, turn
lever (8) to the right (clockwise). (Fig. 7)
3.
While keeping the conditions of Steps 1 and 2,
pull out whole body (7) to disconnect it. (Fig. 8)
18
00-200
200 Foreword and general information
Method of disconnecting and connecting of push-pull type
Connection
1.
While holding the fitting, push body (7) in
straight until sliding prevention ring (6) hits
contact surface (a) at the hexagonal part on
the male side to connect it. (Fig. 9)
PC200, 200LC, 220, 220LC-8M0