ABB ACSM1 Firmware Manual page 78

78
1.10 ENCODER 2 SPEED
Encoder 2 speed in rpm.
1.11 ENCODER 2 POS
Actual position of encoder 2 within one revolution.
1.12 POS ACT
Actual position of the encoder. The unit depends on parameter
1.13 POS 2ND ENC
Scaled actual position of encoder 2 in revolutions.
1.14 SPEED ESTIMATED
Estimated motor speed in rpm.
1.15 TEMP INVERTER
Measured temperature of the heatsink in Celsius.
1.16 TEMP BC
Brake chopper IGBT temperature in Celsius.
1.17 MOTOR TEMP
Measured motor temperature in Celsius.
1.18 MOTOR TEMP EST
Estimated motor temperature in Celsius.
1.19 USED SUPPLY VOLT
Either the nominal supply voltage defined by parameter
automatically determined supply voltage if auto-identification is enabled by parameter
SUPPLVOLTAUTO-ID.
1.20 BRAKE RES LOAD
Estimated temperature of the braking resistor. The value is given in percent of the temperature the
resistor reaches when loaded with the power defined by parameter
1.21 CPU USAGE
Microprocessor load in percent.
1.22 INVERTER POWER
Drive output power in kilowatts.
1.26 ON TIME COUNTER
This counter runs when the drive is powered. The counter can be reset using the DriveStudio tool.
Parameters and firmware blocks
FW block: ENCODER (page 225)
FW block: ENCODER (page 225)
FW block: POS FEEDBACK
FW block: POS FEEDBACK
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
FW block: MOT THERM PROT
FW block: MOT THERM PROT
FW block: VOLTAGE CTRL
47.04 SUPPLY
FW block: ACTUAL VALUES
FW block: None
FW block: ACTUAL VALUES
FW block: ACTUAL VALUES
(page 192)
60.05 POS UNIT selection.
(page 192)
(see above)
(see above)
(see above)
(page 169)
(page 169)
(page 176)
VOLTAGE, or the
(see above)
48.04 BR POWER MAX
(see above)
(see above)
47.03
CNT.