Group
52 FBA DATA IN
These parameters select the data to be sent by the drive to the fieldbus controller,
and need to be set only if a fieldbus adapter module is installed. See also
A – Fieldbus control
Notes:
• This parameter group is presented in the User's Manual of the fieldbus adapter as
parameter group 3 or C.
• The new settings will take effect when the drive is powered up the next time
(before powering off the drive, wait at least 1 minute), or when parameter
FBA PAR REFRESH
• The maximum number of data words is protocol-dependent.
52
52 FBA DATA IN
52.01 FBA DATA IN1
Selects data to be transferred from the drive to the fieldbus controller.
0
4
5
6
14
15
16
101...9999
52.02 FBA DATA IN2
...
...
52.12 FBA DATA IN12
See
on page 385.
is activated.
52.01 FBA DATA
IN1.
FW block: None
Not in use.
Status Word (16 bits).
Actual value 1 (16 bits).
Actual value 2 (16 bits).
Status Word (32 bits).
Actual value 1 (32 bits).
Actual value 2 (32 bits).
Parameter index.
FW block: None
FW block: None
Appendix
Parameters and firmware blocks
185
51.27