Managing Devices - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
LCD
----End

6.2.34 Managing Devices

You can search, add, delete, and assign addresses to devices that are connected to the
SmartLogger on the monitoring panel.
Context








Issue 12 (2019-01-15)
Provided that all the inverters are correctly connected to the SmartLogger and that all the
communications parameters are correctly set, the SmartLogger can perform the
automatic search and detect all the connected inverters.
Before you perform the Auto. Search operation, if the SmartLogger is connected to
devices that no longer exist in the PV power system, remove them from the SmartLogger
manually. Otherwise, these devices are still detectable with Disconnection status.
After you add, delete, or replace a device, or change the RS485 address, search for
devices again or restart the SmartLogger (the SmartLogger automatically searches for
devices after it restarts).
EMI, slave SmartLogger, power meter, PLC, and third-party devices cannot be
automatically recognized, and must be manually added.
For devices that no longer exist in the PV power system, perform Single Remove or
Batch Remove in time to avoid wasting the system resources.
The RS485 addresses of all inverters are the same when delivered. If the firmware
version of the SUN2000 is V100R001C00SPC010 or later, or V100R001C81SPC105 or
later, you can perform automatic address assignment on the SmartLogger and adjust the
addresses to realize remote site setup and improve maintenance efficiency.
When connecting a third-party device, you need to import a configuration file for the
device, and then manually add the device.
If you perform Alarm Reset, all active and historical alarms for the selected device will
be deleted and the SmartLogger will be enabled to collect new alarm data.
Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
6. After the configuration file is imported,
choose Latest Status to view the import status
of the last offline configuration file and choose
Enable offline config to import other offline
configuration files.
6 User Interface
137