Huawei SmartLogger1000 User Manual page 141

SmartLogger1000
User Manual






Procedure

LCD
Issue 12 (2019-01-15)
You have obtained the upgrade package with the help of the supplier or Huawei engineers.
Save the package under the root directory and do not extract the package.
When upgrading the firmware for the SUN2000, change the file name of the package to
sun2000_usb.zip.
When upgrading the firmware for the PID, change the file name of the package to
pid_usb.zip.
When upgrading the firmware for the PLC, change the file name of the package to
plc_usb.zip.
When upgrading the SmartLogger1000, ensure that the file name of the package is
logger_usb.tar.gz.
The following table describes the procedure for upgrading the firmware by using a USB
flash drive. The parameter values in the figures are for reference only.
Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
1. On the default screen, press
the main menu.
2. Choose and press
3. Enter the User Name and Password by
pressing or , and then press
NOTE

Because of the limited permission, select the
User Name as Advanced User or Special
User. The initial password for Advanced User
and Special User is 000001.

After passing the permission validation, the
system keeps the authentication information for
30 seconds. If you exit the screen and log in
again within the 30 seconds, no permission
authentication is required.
6 User Interface
to enter
.
.
128