Huawei SmartLogger1000 User Manual page 134

SmartLogger1000
User Manual
LCD
Issue 12 (2019-01-15) Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
9. Tap , choose Management System, and
tap .
10. After setting the management system
parameters, tap .
 Server: Fill in the IP address of the NMS
server.

Port number: When the SmartLogger
connects to the Huawei NMS, the port
number is 16100 by default. When the
SmartLogger connects to a third-party
NMS, set Port number according to the
server port enabled in the third-party NMS.

In most cases, set Address mode to
Comm. Address. If the devices connected
to the three RS485 ports of the
SmartLogger have duplicate addresses, you
must set Address mode to Logical addr..
 If SSL encrypt. is set to Disable, data will
be transmitted without being encrypted,
which may result in user data theft.
Therefore, exercise caution when deciding
to enable this function.
 If 2nd challenge is set to Disable, the
secondary challenge authentication result is
not checked, which may result in user data
theft. Therefore, exercise caution when
deciding to enable this function.
11. Press , select Modbus TCP, and press
.
6 User Interface
121