Huawei SmartLogger1000 User Manual page 132

SmartLogger1000
User Manual
LCD
Here use the pages displayed when you
log in to the SmartLogger as Advanced
User.
Issue 12 (2019-01-15) Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
3. Set User Name and Password by pressing
or , and press
NOTE

Set User Name to Advanced User. The initial
password for Advanced User is 000001.

After passing the permission validation, the
system keeps the authentication information for
30 seconds. If you exit from the Settings screen
and log in again within 30 seconds, no
authentication is required.
4. Select Comm. Param. and press

Perform step 5 and step 6 to set the
parameters for the RS485.
 Perform step 7 and step 8 to set the
parameters for the Ethernet.

Perform step 9 and step 10 to set the
management parameters.
 Perform step 11 and step 12 to set the
parameters for the Modbus TCP.

Perform step 13 and step 14 to set the
parameters for the IEC103.
 Perform step 15 to set the SmartLogger
address.
5. Select an RS485 port by pressing
and then press
There are three RS485 ports: RS485-1,
RS485-2, and RS485-3. The corresponding
port for RS485-1 is COM1; RS485-2 is
COM2; RS485-3 is COM3.
6 User Interface
.
.
or
.
119