Configuration; Jumper Locations; Default Link Settings - GE SBC330 3U VPX Hardware Reference Manual

4 • Configuration

4.1 Jumper Locations

4.2 Default Link Settings

Publication No. SBC330-0HH/3
This section describes the configuration of jumpers on the SBC330. The board is
delivered with push‐on links, but for more rugged or military applications,
jumper pins must be connected using wire wraps and conformal‐coat.
The SBC330 has two banks of 4 x 2‐way jumpers that affect booting and need to be
set correctly.
The SBC330 is shipped from the factory with some links fitted. This simplifies the
most likely use of the SBC330. Some jumpers are essential and some are not.
Before changing any of the link options, refer to the following sections.
NOTE
If you are about to install your board and power-up for the first time, leaving your board in the
default configuration will enable board operation to be proven prior to tackling any further
configuration issues.

Configuration 19