Viewing Phone Information; Viewing Reboot Reasons - Cisco Small Business SPA509G Administration Manual

Getting Started

Viewing Phone Information

Viewing Phone Information
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
After you log on to the configuration utility (see
Configuration Utility" section on page
the Cisco SPA IP Phone by clicking the Info tab. The Info tab shows information
about all phone extensions, including phone statistics and the registration status.
All fields are read-only.
See "Info Tab" section on page 228

Viewing Reboot Reasons

The phone stores the most recent five reboot/refresh reasons. When the phone is
reset to factory defaults, this information is deleted.
The following is a list of the supported reboot/refresh reasons (SPA50X and
SPA30X):
Reason
DHCP Failed
Upgrade
Provisioning
SIP Triggered
Link Down
VLAN Changed
RC
User Triggered
"Using the Web-Based
21), you can check the current status of
for more information about the fields.
Description
The reboot was the result of a DHCP error caused
when the lease expired, or when the renewal or
verification failed.
The reboot was a result of an upgrade operation
(regardless whether the upgrade completed or
failed).
The reboot was the result of changes made to
parameter values via the phone's LCD or Web GUI, or
as a result of a resync.
The reboot was triggered by a SIP request.
The reboot was triggered when the link to the
network went down.
The reboot was triggered when the VLAN was
changed.
The reboot was triggered as a result of remote
customization.
The user manually triggered a warm reboot.
1
28