Configuring Power Settings; Configuring Pppoe Settings (Cisco Spa525G/525G2 Only) - Cisco Small Business SPA509G Administration Manual

Configuring Security, Quality, and Network Features
Configuring Domain and Internet Settings
STEP 5
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
- 100Mbps/Duplex
- 100MBps/Half
Click Submit All Changes.
For the Cisco SPA301 and Cisco SPA501G, can be configured using the IVR. See
the "Using IVR on the Cisco SPA301 and Cisco SPA501G IP Phone" section on
page 30.

Configuring Power Settings

To configure PoE power requirements to a PoE switch:
Log in to the configuration utility.
Click Admin Login and advanced.
Click the System tab.
Configure the following field:
Parameter
PoE Power Required
Click Submit All Changes.

Configuring PPPoE Settings (Cisco SPA525G/525G2 only)

If you configured PPPoE as the internet connection type:
Description
Specifies the PoE power setting: Normal (default) or
Maximum.
When one or more attendant consoles are attached to
the phone, use Maximum to advertise to a PoE switch
that the phone will consume up to 12 W.
When no attendant consoles are attached, use
Minimum to advertise a required power budget of 6.5
Watts.
This parameter is not applicable to SPA301 and
SPA303 because they do not have attendant console
support.
5
148