Digit Sequence Examples - Cisco Small Business SPA509G Administration Manual

Configuring Dial Plans
About Dial Plans
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Digit Sequence
,
(comma)
!
(exclamation point)
*xx
S0 or L0
P
The Cisco SPA 9000 and the Cisco IP phones implicitly append the vertical code
sequences entered in the regional parameter settings to the end of the dial plan.
Likewise, if Enable_IP_Dialing is enabled, then IP dialing is also accepted on the
associated line.

Digit Sequence Examples

The following examples show digit sequences that you can enter in a dial plan.
In a complete dial plan entry, sequences are separated by a pipe character (| ) , and
the entire set of sequences is enclosed within parentheses.
EXAMPLE: ( [1-8]xx | 9, xxxxxxx | 9, <:1>[2-9]xxxxxxxxx | 8,
<:1212>xxxxxxx | 9, 1 [2-9] xxxxxxxxx | 9, 1 900 xxxxxxx ! |
9, 011xxxxxx. | 0 | [49]11 )
Function
For an intersequence tone, enter a comma between
digits to play an "outside line" dial tone after a user-
entered sequence.
9, 1xxxxxxxxxx
EXAMPLE:
An "outside line" dial tone is sounded after the user
presses 9, and the tone continues until the user
presses 1.
For number barring, enter an exclamation point to
prohibit a dial sequence pattern.
1900xxxxxxx!
EXAMPLE:
The system rejects any 11-digit sequence that begins
with 1900.
Enter an asterisk to allow the user to enter a 2-digit star
code.
For Interdigit Timer Master Override, enter
reduce the short inter-digit timer to 0 seconds, or enter
L0 to reduce the long inter-digit timer to 0 seconds.
P
For a pause, enter followed by a number and a space.
The duration of the pause is the specified number of
seconds. This feature is typically used for
implementation of a hot line and warm line, with 0 delay
for the hot line and a non-zero delay for a warm line.
P5
EXAMPLE:
8
S0
to
204