Cisco Small Business SPA509G Administration Manual page 74

Customizing Cisco SPA and Wireless IP Phones
Configuring Ring Tones
STEP 3
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Click the Phone tab and proceed to the Ring Tone section.
You can configure the characteristics of each ring tone using a Ring Tone script. In
a Ring Tone script, you can assign a name for the ring tone, and specify:
• Name (n)—Ring tone name, such as Classic, Simple, and Office
• Waveform (w):
- (SPA50X/SPA30X) 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
- (SPA525G/525G2) 1, 2, 3, 4, file://Pulse1.raw, file://Ring7.raw, file://
Warble.raw, w=file://Low.raw, file://Floor.raw, file://Reverb.raw
• Cadence (c)—1, 2, 3, 4, or 5
You can also use the configuration file to configure ring tone. For example, to
configure Ring1 to play the Warble ring tone, change the Ring1 parameter as
follows
• (SPA50X/SPA30X)
<Ring1 ua="na">n=warble;w=7;c=1</Ring1>
• (SPA525G/525G2)
<Ring1 ua="na">n=warble;w=file://Warble.raw;c=1</Ring1>
You can also download one of two available ring tones (user ring tone 1 or 2) using
TFTP:
http://phone_ip_addr/ringtone1?[url]
• Where the URL syntax is tftp:
• The default host is the TFTP host.
• Port is optional. The default port is 69.
• The link is case sensitive.
On the IP phones, user-downloaded ring tones are labeled User 1 and User 2 in
the choices for the Default Ring. On the phone ring tone menu, the User 1 and 2
choices are replaced by the corresponding name of the ring tone. "Not Installed"
appears if the user ring tone slots are not used.
For ring tone User 1 and User2, the cadence is fixed with the on-time equals to the
duration of the ring tone file and off-time equals to four seconds. The total ring
duration is fixed at 60 seconds. The user ring tone names displayed on the phone
LCD are derived from the ring tone file header file.
//host[:port]/path
.
3
73