Line Key Led Pattern - Cisco Small Business SPA509G Administration Manual

Cisco SPA IP Phone Field Reference
Phone Tab
NOTE
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
Parameter
SCA Line ID Mapping
SCA Barge-In Enable
SCA Sticky Auto Line Seize
Call Appearance Per Line

Line Key LED Pattern

Does not apply to the WIP310.
Parameter
Idle LED
Description
Specifies the shared call appearance line ID mapping.
Choose Vertical First or Horizontal First. Each LED can
hold multiple calls and the first call on an LED makes it
light up. Horizontal first means the second call makes
the same LED flash. Vertical first means the second call
lights up the next LED.
For example, if Extension 101 is assigned to two LEDs,
and Vertical First is selected, the second call on
Extension 101 lights up the second LED. The third call
makes the first LED flash, and the fourth call makes the
second LED flash.
If Horizontal First is selected, the second call on
Extension 101 makes the first LED flash. The third call
lights up the second LED, and the fourth call makes the
second LED flash.
Enables the SCA Barge-In.
Defaults to no.
When enabled, taking the phone off-hook will not
automatically pick up an incoming call on a shared line.
Specifies how many calls per line to allow. You can
choose a value from 2 (default) to the maximum value
of 10. This parameter is not supported on the
SPA501G and SPA301 phones. Also, this parameter is
only supported when the phones are operating in the
SIP mode.
Description
LED pattern during the Idle state, where the call
appearance is not is in use and is available to make a
new call. Leaving this entry blank indicates the default
value of c=g.
B
285