Cisco Small Business SPA509G Administration Manual page 169

Provisioning Basics
Provisioning Capabilities
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide
tftp://192.168.1.5/spa504.cfg
If no protocol is specified, TFTP is assumed. If no server-name is specified, the
host that requests the URL is used as
If no port is specified, the default port is used (69 for TFTP, 80 for HTTP, and 443
for HTTPS). then the address can be entered in and press Resync.
The status of the remote customization process is shown by the phone's mute
button blinking in the following patterns:
• Red/orange slow blink (1.0 seconds on, 1.0 seconds off): Contacting server,
server not resolvable, not reachable, or down
• Red/orange slow blink (0.2 seconds on, 0.2 seconds off, 0.2 seconds on, 1.4
seconds off): Server responded with file not found or corrupt file
WIP310
Press the Select button to choose
Misc Settings
Navigate to
Navigate to profile rule. Enter the profile rule in the following format:
protocol :// server[:port]/profile_pathname
For example, to have the WIP310 provisioning done by the Cisco SPA 9000
Voice System, enter:
192.168.2.64/cfg/generic.xml
SPA525G/525G2
Press the Setup button.
Scroll to Device Administration and press Select.
Scroll to Profile Rule and press Select.
Enter the profile rule using the following format, then press the Resync soft button.
protocol://server[:port]/profile_pathname
For example:
server-name
Settings and press the Select button again.
.
.
6
168