6860 Remote Annunciator Installation - Honeywell 6820 Manual

6860 Remote Annunciator Installation

4. Wire the annunciator to the FACP as shown below.
5. Replace the electronic assembly in the backbox. Place the bezel over the backbox and tighten the set screws on the bezel. Refer to
Figure 4.20 for location of set screws.
4.9 6860 Remote Annunciator Installation
The optional 6860 Remote Annunciator can be surface or flush mounted.
6860 installation involves the following steps:
1. Ensure power is off at the panel.
2. Mount the 6860 in the desired location (see Section 4.9.1).
3. Connect the 6860 to the panel (see Section 4.9.2).
4. Use the DIP switches on the back of the 6860 to assign an SBUS ID# (see Section 4.15.1).
5. The 6860 module must be added to the system through programming. JumpStart Auto-Programming will add the module automatically
(see Section 8.6.7).
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
EXT. COMM
Figure 4.22 5860 Connection to the Panel
BACK BACK
NEXT NEXT
Figure 4.23 6860 Remote Annunciator
supervised,
power-limited
BACK
NEXT
Model 6860
Control Panel Installation
39