1: 5815Xl Connection To The Panel; 6815 Installation - Honeywell 6820 Manual

Control Panel Installation
Figure 4.28 is a drawing of the 5815XL board, showing the location of terminals and DIP switches.
4.10.1 5815XL Connection to the Panel
Connect the 5815XL to the control panel as shown in Figure 4.29. After the 5815XL is connected to the panel, it must be added to the sys-
tem. This programming steps are described in Section 8.2.2.
FACP
EXT. COMM

4.11 6815 Installation

The 6815 SLC expander lets you add additional addressable devices. The maximum number of SK SLC devices per panel is 1,110. The
number of s is limited by the maximum number of SBUS devices.
NOTE: An external 6815 will support SK or SWIFT SLC devices.
To install the 6815:
1. Make sure power is off at the panel.
2. Mount the 6815 in the 6820 cabinet, the 5895XL cabinet, or the 5815RMK remote mounting kit. Use the standoffs located under the
control panel board assembly and secure with screws provided with the 6815. For additional information see the 5895XL Installation
Manual .
3. Connect the 6815 to the control panel. (See Section 4.11.1.)
4. Use the onboard DIP switches to select an SBUS ID#. (See Section 4.15.1.)
5. Add the 6815 module to the system through programming. JumpStart will add the module automatically (see Section 7.1). You can also
add it manually (see Section 8.2.2). Select a name, if desired (see "Naming Modules" on page 91).
You are now ready to connect SLC devices to the 6815 (see Section 8.5.2).
42
address DIP
switch
to panel via SBUS
–
+
A B
S B U S
Figure 4.28 5815XL Board
5815XL
–
+
A B S C -
S B U S S L C O U T
Figure 4.29 5815XL Connection to FACP
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
to SLC loop
S C - S + S C - S +
S L C O U T S L C IN
–
+
S + S C - S + A
S L C IN S B U S
6815 Installation
5815XL
B S C - S + S C - S +
S L C O U T S L C IN
supervised,
power-limited