1: Recording Messages 1-15 Using Aux Audio Input - Honeywell 6820 Manual

Emergency Voice System Operation
When in the record mode, the EVS-VCM keys will function as follows:
Select Keys
While in the Local Record mode, Select Keys 1-15 will be used to reference message slots 1-15. The associated green Select Key LED will
indicate that a message is currently programmed in the corresponding slot. When there is no message recorded (or the message is erased), the
associated green Select Key LED will be off. While recording a particular message, the associated red Select Key LED will turn on until
recording is completed. The Select Key 1-15 will be used to playback a recorded message or to select the message slot to record to or erase.
When in the Local Record mode, the EVS-VCM LEDs will function as follows:
Switch LED
Select key 1-15 Green LED
Select key 1-15 Red LED
Select key 1-15 Green/Red LED
Select key 1-15 Red LED
10.8.1 Recording Messages 1-15 Using Aux Audio Input
Recording messages from the Aux Audio Input enables you to load customized, pre-recorded messages into an EVS message location.
Follow these steps to record a user message using Aux Audio Input.
1. Wire a speaker cable with 1/8" mini plug to the Aux AUDIO GND and IN terminals. Refer to Figure 10.5.
134
READY
ALL CALL
TO TALK
1-15
Key
EVS Message Key 1
EVS Message Key 3
EVS Message Key 8
Select Keys 1-15
Active LED Status
On
On
Off/Off
Flashing
NON-ACTIVE
ECS CONTROL
CALL
Function
Select message slot to record
Start and stop recording from Aux Audio Input
Erase user message 1-15
Message storage lot 1-15
Message is currently programmed in this slot
Message recording is in progress
Message slot is empty
Message is being played back or message is selected for recording
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
Recording Custom Messages
ECS Message Key 1
ECS Message Key 3
ECS Message Key 8
Action