Honeywell 6820 Manual page 121

Operation Mode Behavior
Operating
Occurs When
Mode
Normal No alarm, supervisory,
or trouble condition
exists and menus are
not in use.
Alarm
A smoke detector
goes into alarm or a
pull station is
activated.
CO detector goes into
alarm.
If more than 3
categories are active
at a single time, the
screen will display as
shown.
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
System Behavior
SYSTEM POWER LED is on.
The All Systems Normal display indicates that the
system is in normal mode. The current date and time
display on the last line of the LCD.
Site 1
Model 6820
ALL SYSTEMS NORMAL
08/03/21 01:45:52PM
The system will report events to the central station.
The onboard annunciator will sound loud, steady
beeps to distinguish alarm signals. For a fire alarm,
the sequence is a loud steady beep.(Any notification
devices attached to the system will also sound). For
an EVS Alarm, the sequence is four seconds on, one
second off.
The GENERAL ALARM LED flashes.
The LCD displays a screen similar to this one.
FIRE: ALRM
Waterflow SW
Zone_1
1 of 1
Pressing the right arrow key or Info will display the
location macro, date/time stamp, and site/panel
number if applicable.
Site 1
CO ALRM
[Press for status]
Pressing the down arrow key to view the type and
location of alarm. (Message will alternate with the
date/time display.)
FIRE: ALRM SUPR TRBL
CO: ALRM SUPR
SYS: TRBL
Table 9.4 Panel Operating Modes
Enter the appropriate code, or rotate the key to activate
the Main Menu.
Press the down arrow to view the alarm. A screen similar
to this one displays.
ALARM: MAN_PULL
MODULE_33 POINT_2
ZONE_2
Press SILENCE and enter an Access Code (or activate
the key) to silence the annunciator (and any notification
devices attached to the system).
When the alarm condition clears, press RESET and
Info> enter a code (or activate the key) to restore the panel to
normal.
System Operation
In This Mode You Can
device
type
3 of 5
showing 3 of 5 events
121