Step 10: Completing And Saving The Configuration - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Initial System Configuration

Step 10: Completing and Saving the Configuration

When you have completed the entire configuration, the system checks for errors. If errors are
found, a warning message appears. When the configuration is error-free, you may apply and save
it.
To complete and save the configuration, complete the following steps:
Step 1
It is recommended that you view the entire new configuration before it is applied.
Type y and press Enter.
Note that there is no default.
If there are no errors, go to step 3.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
y
Step 2
Press Enter.
Found errors in the new configuration, would you like to view them? [yes]:
The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP
access-class.
Step 3
Apply and Save this configuration? [yes/no]:
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
Step 4
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just
entered, are you sure? [yes/no]:
The selected action is carried out by the system.
Setup procedure aborted, no configuration changes made.
The new running configuration will be saved to the startup configuration.
Step 5
SCE 2000 4xGBE Installation and Configuration Guide
5-24
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
The system informs you that data collection is complete.
If any errors are detected, you may choose to view them.
You are asked whether to apply and save the configuration.
To apply and save the configuration, type y and press Enter.
•
To abort the setup procedure without applying or saving the configuration (recommended
•
if there are errors), type n and press Enter.
If there are no errors, the system requests confirmation of either a yes or no answer, in
order to prevent mistakes.
If the apply and save action is not confirmed (no), the setup is aborted.
•
If the apply and save action is confirmed (yes), the configuration is applied and saved.
•
If the configuration was applied and saved, you may also save it to a file at a remote
station.
OL-7824-02