Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 82

Initial System Configuration
The SNMP agent that resides inside the SCE 2000 will respond only to SET requests that use this
community string.
Enter SNMP SET community name:
Note that there is no default for this parameter.
Step 7
Type a number (1 through 99) or type "0" to permit access to all IP addresses, and press Enter.
Enter Access list number allowing access with this community string, use '0'
to allow all:
Step 8
Would you like to add another SNMP SET community? [no]:y
Enter up to 20 SNMP SET communities as described in step 6 and step 7.
Would you like to add another SNMP SET community? [no]:
Step 9
Would you like to configure SNMP trap managers? [no]: y
Type y and press Enter.
The SNMP trap managers dialog begins.
If you choose not to configure SNMP trap managers, the dialog skips to the authentication failure trap
status. (See step 14.)
Step 10
Enter SNMP trap manager IP address:
Note that there is no default for this parameter.
Step 11
Note that there is no default for this parameter.
Enter SNMP trap manager community string:
Step 12
Note that there is no default for this parameter.
Enter trap manager SNMP version:
Step 13
Would you like to add another SNMP trap manager? [no]:y
Enter up to 20 trap managers as described in step 10 through step 12.
Would you like to add another SNMP trap manager? [no]:
Step 14
SCE 2000 4xGBE Installation and Configuration Guide
5-18
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Assign an access list to restrict the SNMP management stations that may use this SET
community.
The maximum number of SET communities is 20.
• To add more entries, type y and press Enter
When all entries have been added, press Enter
•
Enter the SNMP trap managers menu.
Type the trap manager IP address and press Enter.
Type the trap manager community string and press Enter.
Type the number of the trap manager SNMP version (1 or 2c) and press Enter
The maximum number of trap managers is 20.
• To add more entries, type y and press Enter
When all entries have been added, press Enter
•
Configure the Authentication Failure trap status.
OL-7824-02