Step 5: Configuring The Dns Settings - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Initial System Configuration
Enter time interval in seconds between unicast updates [1024]:
Step 8
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1
E
XAMPLE
Following is a sample time setting dialog. In addition to setting the time zone, time and date are
changed, and SNTP unicast updates are configured.
Would you like to enter the Time settings menu? [no]: y
Enter time zone name [UTC]: ISR
Enter time zone minutes offset from UTC: 120
The local time and date is 15:35:23 ISR FRI July 19 2002
Would you like to set a new time and date? [no]: y
This change will take effect immediately both on the system clock and the
calendar; it will also set the time zone you entered. Are you sure?
[yes/no]: y
Enter new local time and date: 14:35:23 19 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Would you like to enter the SNTP configuration menu? [no]: y
Enable SNTP broadcast client? [no]: y
Enter time interval in seconds between unicast updates [900]:
Would you like to configure SNTP unicast servers? [no]: y
Enter IP address or hostname of SNTP unicast server: 10.1.1.1

Step 5: Configuring the DNS Settings

The DNS configuration menu defines the IP address of the domain name server, which is used for
DNS lookup, as well as the default domain name, which is used to complete unqualified host
names.
You may choose to skip the DNS configuration menu if you wish to accept all default values.
To configure DNS settings, complete the following steps:
Step 1
Would you like to enter the DNS configuration menu? [no]: y
Type y and press Enter.
The DNS settings dialog begins.
Step 2
SCE 2000 4xGBE Installation and Configuration Guide
5-10
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
To accept the displayed default value, press Enter.
•
• To change the value, type the desired number of seconds (64 through 1024) and press
Enter.
You may enter an IP address for the SNTP unicast server. Type in the hostname or the IP
address in the form x.x.x.x, and press Enter
:
Enter the DNS settings menu.
Enable or disable DNS lookup.
To enable DNS lookup, press Enter.
•
To disable DNS lookup, type n and press Enter.
•
OL-7824-02