Step 1: Configuring Initial Settings - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Initial System Configuration
•
•
E
XAMPLE
Would you like to enter the SNMP configuration menu? n
•

Step 1: Configuring Initial Settings

Verify the following initial settings for the SCE 2000:
•
•
•
All values are Internet addresses of the form 'X.X.X.X', where each letter corresponds to a
decimal number between 0 and 255.
To configure the initial settings, complete the following steps:
Step 1
Step 2
Step 3
SCE 2000 4xGBE Installation and Configuration Guide
5-6
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
In certain cases, there will be two or more logically related parameters within a menu. In these
situations, it is not permitted to jump to the end of the setup dialog until all related parameters
are configured. If you try to jump to the end of the setup dialog, the following message will
appear: "
Sorry, Skipping is not allowed at this stage
Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs
or menus within the setup dialog. You may skip an entire menu, thereby accepting all default
values for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter
the menu. To skip the menu, answer no ("n") to the question.
:
To abort the setup dialog at any point without making any configuration changes, press ^c.
All changes already entered will be lost, with the exception of time settings.
IP address
Subnet mask
Default gateway
The current IP address is displayed.
To accept the displayed value, press Enter.
•
• To change the value, type the desired value in the format "x.x.x.x" and press Enter.
The current subnet mask is displayed.
To accept the displayed value, press Enter.
•
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
•
The current IP address of the default gateway is displayed.
To accept the displayed value, press Enter.
•
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
•
."
OL-7824-02