Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 73

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
You must enter the time setting menu in order to configure SNTP settings. You may choose to
skip the time settings menu if you wish to accept all default values.
Unlike all other settings defined in the system configuration, setting the time is done immediately and
Note
not at the end of the setup process.
To configure the time settings, complete the following steps:
Step 1
Would you like to enter the Time settings menu? [no]: y
Type y and press Enter.
The time settings dialog begins.
Step 2
Enter time zone name [UTC]: CET
Step 3
Enter time zone minutes offset from UTC: 60
The local time and date are displayed, and you are asked whether you want to change them.
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
Step 4
If the time and date are not correct, answer yes to the above question, and press Enter.
Would you like to set a new time and date? [no]: y
Confirm your response and type the new time and date.
This change will take effect immediately both on the system clock and the
calendar; it will also set the time zone you entered. Are you sure?
[yes/no]: y
Enter new local time and date: 14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Step 5
If you do not wish to configure the SNTP, skip the rest of this section and go to Step 5: Configuring the
DNS Settings (on page 5-10).
To enter the SNTP configuration dialog, type y, and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Step 6
Enable SNTP broadcast client? [no]:
Step 7
OL-7824-02
Enter the time settings menu.
Type the time zone abbreviation and press Enter.
Type the minutes offset from UTC and press Enter.
If the time and date are correct, go to step 5.
You are asked whether you wish to enter the SNTP configuration menu.
Configure the SNTP broadcast client. By default the SNTP broadcast client is not
enabled.
To disable the SNTP broadcast client, press Enter.
•
To enable the SNTP broadcast client, type y and press Enter.
•
Define the time interval between unicast updates.
SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-9