Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 75

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Enable IP DNS-based hostname translation? [yes]:
If you choose to disable DNS lookup, skip the rest of this section and go to Step 6: Configuring the RDR
Formatter Destination (on page 5-12). The rest of the dialog is not presented, as it is irrelevant when DNS
lookup is disabled.
Step 3
Note that there is no default domain name.
You may accept the default domain name or enter a new one.
Enter default domain name []:
Step 4
Enter Primary DNS IP address:
Note that there is no default for this parameter.
Step 5
Would you like to add another Name Server? [no]:
You are asked to enter the IP address of the next domain name server.
Enter Secondary DNS IP address:
Step 6
Would you like to add another Name Server? [no]:
E
XAMPLE
Following is a sample DNS configuration dialog. The default domain name is pcube.com, and the
IP address of the Domain Name Server is 10.1.1.230.
Would you like to enter the DNS configuration menu? [no]: y
Enable IP DNS-based hostname translation? [yes]:
Enter default domain name []: pcube.com
Enter Primary DNS IP address: 10.1.1.230
Would you like to add another Name Server? [no]:
OL-7824-02
Type the default domain name to be used, and press Enter.
Type the IP address of the primary domain name server and press Enter.
You may configure up to three domain servers.
To exit the DNS settings dialog, press Enter.
•
To add another domain server, type y and press Enter.
•
When IP addresses for all servers have been entered, exit the dialog by pressing Enter.
:
SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-11