Verifying The Initial Configuration; Completing The Configuration - Cisco 1841 User Manual

Initial Configuration of the Router
•
•
•
Cisco Router and Security Device Manager
If the Cisco Router and Security Device Manager (SDM) has been installed on your router, the following
messages appear at the end of the startup sequence:
yourname con0 is now available
Press RETURN to get started.
For instructions on configuring your router by using SDM, see the
Manager (SDM) Quick Start
instructions for installing it on your router:
http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to
www.cisco.com/go/sdm.

Verifying the Initial Configuration

Verify that the new interfaces are operating correctly by performing the following tests:
•
•
•
When you have completed and verified the initial configuration, your Cisco router is ready to be
configured for specific functions. See the
information about locating documentation for advanced configuration procedures.

Completing the Configuration

When you have completed and verified the initial configuration, your Cisco router is ready to be
configured for specific functions. For advanced configuration procedures, use either SDM or the CLI.
For configuration procedures using SDM, see
Start
For configuration procedures using the CLI, see
software configuration documents include information about the following topics:
•
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
7-6
Cisco Router and Security Device Manager—See the
section on page 7-6
Setup command facility—See the
in the Cisco 1800 Series Integrated Services Routers (Modular) Quick Start Guide.
Command-line interface (CLI)—See the
Configuration" section in the
Guide.
Guide. To use SDM, you can download the latest version of SDM and
Enter the show interfaces command to verify that the interfaces are operating correctly and that the
interfaces and line protocol are in the correct state—up or down.
Enter the show ip interface brief command to display a summary status of the interfaces configured
for IP.
Enter the show configuration command to verify that you configured the correct hostname and
password.
Guide.
Basic software configuration
Chapter 7 Power-Up Procedures for Cisco 1800 Series Routers (Modular)
"Cisco Router and Security Device Manager"
"Initial Configuration Using the Setup Command Facility"
"Initial Configuration Using Cisco CLI—Manual
Cisco 1800 Series Integrated Services Routers (Modular) Quick Start
"Completing the Configuration" section on page 7-6
Cisco Router and Security Device Manager (SDM) Quick
Cisco 1800 Series Router Software
Cisco Router and Security Device
Configuration. The
OL-5876-03
section
for