Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 151

Physically connected link • 3-9, 5-19, 6-12
Physically Connected Links Parameter • 3-9
Power
turning on • 7-2
Power Supply Overview • 4-14
Power Supply Specifications • 4-17
Powering Down a DC-Input Power Supply
Unit and Removing the DC-Input Leads •
4-19
Powering Down an AC-Input Power Supply
• 4-18
Powering Down the Power Supply Unit and
Disconnecting Input Power • 4-18
Preface • v
Preparing to Install the SCE 2000 Platform •
4-1
Priority • 3-9, 6-13
Problem Solving Using a Subsystems
Approach • 8-8
R
Rack, mounting to • 4-7
Rack-Mounting a SCE 2000 Platform • 4-7
RDR formatter
destinations • 5-11
Reboot, status after • 5-19
Rebooting and Shutting Down the SCE
Platform • 7-11
Rebooting the SCE Platform • 7-11
Reconnecting AC-Input Power Supply Unit
• 4-21
Reconnecting DC-Input Power Supply Unit
• 4-22
Reconnecting the Power • 4-20
Recovering a Previous Configuration • 7-9
Redundancy • 3-2
Related Publications • vi
Removing and Replacing a Power Supply
Unit • 4-17
Removing and Replacing the Fan Module •
4-24
Removing the Fan Module • 4-25
Removing the Power Supply Unit • 4-19
Replacing the Battery • 4-26
Replacing the Fan Module • 4-25
Replacing the Power Supply Unit • 4-20
Requirements
OL-7824-02
site • 4-3, 4-4
S
Saving the Configuration Settings • 7-7
SCE 2000 Component List • 2-7
SCE 2000 Configuration • 3-8
SCE 2000 Installation Checklist • 2-8
SCE 2000 Operational Status • 8-7
SCE Platform
front panel • 2-3
SCE Platform Management Interfaces • 1-2
Service Control and the SCE Platform • 2-1
Service Control Management • 2-2
Setting Up the Local Console • 5-2
setup • 5-3
Shutting Down the SCE Platform • 7-11
Single Link
Inline Topology • 3-5, 6-2
Receive-only Topology • 3-4, 6-3
Single SCE 2000 Topologies • 3-4
Site Requirement Guidelines • 4-3
Site Requirements • 4-4
SNMP (Simple Network Management
Protocol) • 5-16
SNTP • 5-8
Specifications • A-7
Starting the SCE 2000 Platform • 7-1
Starting the System and Observing Initial
Conditions • 7-2
Step 1
Configuring Initial Settings • 5-6
Step 10
Completing and Saving the
Configuration • 5-23
Step 2
Configuring the Hostname • 5-7
Step 3
Setting the Passwords • 5-7
Step 4
Configuring Time Settings • 5-8
Step 5
Configuring the DNS Settings • 5-10
Step 6
Configuring the RDR Formatter
Destination • 5-11
Step 7
Configuring Access Control Lists
(ACLs) • 5-12
Step 8
SCE 2000 4xGBE Installation and Configuration Guide
Index
3